![]() This means that you have to learn to organize your information, and that is. I think what I'm trying to figure out is if the origin of my viewports should be on the design layer or on the sheet layer showing the floor plan that I'm taking the section from? Again, this probably sounds really thick, but I'm having a hard time finding out if there's a benefit to doing it one way over the other. With Vectorworks, you have the ability to create several drawings from one file. I noticed that I can also draw section lines on this drawing and again have the resulting viewport set to show up on a sheet layer set up for my building sections. This same floor plan is also shown as a viewport on a sheet layer that I have set up for floor plans. This year, we have created a new delivery format that we hope will make it easier for you to get started with Vectorworks. If the layer name passed to the procedure already exists, the procedure switches the active layer to the specified layer. Layer can also be used to switch the active layer of the document. ![]() After creation, the new layer becomes the active layer of the document. I have always drawn the section line here and then have the resulting viewport placed on a sheet layer that I've designated for building sections. This guide is designed to provide you with a strong base as you learn to use Vectorworks to design, communicate, and document the ideas that you are passionate about. Procedure Layer creates a new layer in a VectorWorks document. Should I be drawing it on the design layer, or should I be drawing it on the View Port that is located on the sheet layer? For example, I have a floor plan that I develop in the design layer. ![]() Just wanted to add that I hope I'm being clear that where I'm confused is where I initially should be drawing the section line itself. Sorry to come off as thick, but I don't understand when I would chose one over the other. the sheet layer? I suppose what I'm trying to figure out is what the differences between the two are and when they should be applied. So, what are the functional differences between section view ports drawn in the design layer vs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |